센서

Four types for detecting existence, four types for alignment, and one for mapping are available, making for a total of 9.

New models for 32 mm wide and 11 mm wide types in addition to new 40 mm wide type. Five models are available as optimal solutions for the detection of workpieces with complex shapes, as well as for the detection of workpiece passage locations and shapes that are not fixed.

Fine spot lens NF-DA03 and coaxial diffuse fiber unit NF-DK21 enables ø0.2 mm spot.

Built-in polarizing filter type and narrow view type

The NF-TR14 can be used as a side view type by bending the fiber cable to fit the slit in the side of the nut. This fiber unit is a completely new concept that allows switching between side view and straight view according to mounting conditions.

The fiber unit for the flexible type (R1 mm) has an allowable bending radius of 1 mm ! Cable can be installed without worrying about damaging the fiber. *If fibers are to be bent repeatedly, such as when mounted on moving parts, please select a flexible fiber.

Withstands 800,000 cycle bending test at a load of 50 g !* Because of high photo-conductivity with a less than 10% light deterioration rate, this sensor is optimal for mounting on moving parts such as robot arms.

The fine tipped side view sleeve type eliminates mounting space problems. Optimal for detection in complex areas, such as for connector pin detection.

Long sleeve type can be bent (up to R10 mm). Fine tuning of the sensing position is possible even after the mounting position has been determined.

Fiber unit with a core diameter of Φ0.25 to 0.5 mm. Recommended for small object detection or high accuracy positioning purposes.

The NF-TR14 can be used as a side view type by bending the fiber cable to fit the slit in the side of the nut. This fiber unit is a completely new concept that allows switching between side view and straight view according to mounting conditions.

Head ON/Side ON switchable type